例句與造句

1. The branch currents are written in terms of the circuit node voltages.
2. When working with multi-pin connectors, it is helpful to have a pinout diagram to identify the wire or circuit node connected to each pin.
3. Pinholes would defeat the purpose of the coating, because a continuous contaminant film would be able to make contact with the circuit nodes and form undesired conductive paths between them.
4. A coating preserves the performance of precision electronics primarily by preventing ionizable contaminants such as salts from reaching circuit nodes, and combining there with water to form a microscopically thin electrolyte film.
5. Toggling a voltage at a circuit node requires charging or discharging the capacitance at that node; since currents are related to voltage, the time it takes depends on the voltage applied.
6. It's difficult to find circuit nodes in a sentence. 用circuit nodes造句挺難的
7. :: : * With the vast increases in the density of integrated circuits, it became harder and harder to access the internal circuit nodes to which the lights would have been connected.
8. In a logic circuit, Q crit is defined as the minimum amount of induced charge required at a circuit node to cause a voltage pulse to propagate from that node to the output and be of sufficient duration and magnitude to be reliably latched.
9. The cube has a circuit node at each of its 8 vertices and an equal resistor ( " R " say ) along each of its 12 edges; what is the resistance between any two opposite corners ( i . e . along a'3D diagonal'of the cube )?
10. The main difference between speed-independent and QDI circuits is that in QDI circuits, the designer is concerned with the acknowledgment of each transition, whereas in speed-independent design, the correctness of the isochronic assumption on each circuit node is assumed to be true and no distinction is made between circuit nodes that are isochronic forks and those that are not.
11. The main difference between speed-independent and QDI circuits is that in QDI circuits, the designer is concerned with the acknowledgment of each transition, whereas in speed-independent design, the correctness of the isochronic assumption on each circuit node is assumed to be true and no distinction is made between circuit nodes that are isochronic forks and those that are not.